Kb-electronics KBSI-240D KBSI Signal Isolator Uživatelský manuál

INSTALLATION AND OPERATING INSTRUCTIONSMODEL KBSI-240DSignal Isolator KB Part No. 9431See Safety Warning on Page 1The information contained in this ma

a) Connect the armature of the main motor to the SI input terminals “5” (-) and “7” (+).b) Set the armature voltage of the main motor to zero (0). Ad

9Isolation DiodeF(-)A(-)A(-)A(+)A(+)AdditionalFollowersFollowerMotor #1FollowerMotor #2FollowerMotor #3A(-)A(+)P2F(-)P2F(-)P29(-)10(+)KBSI-240D57Main

10MotorA(-)F(-)A(+)P35K PotAuto/Man10(+)9(-)Manual5K Speed PotP2P1KBCONTROLKBSI-240DThe KBSI-240D canbe wired in anAuto/Manual modewhich will all

Note: The preceding circuit provides for the speed pot to be used in “MAN” mode only. In “AUT0”mode, the process control signal is supplied directly

– NOTES –12

– NOTES –13

V. LIMITED WARRANTYFor a period of 18 months from the date of original purchase, KB Electronics, Inc. will repair orreplace, without charge, devices w

TABLE OF CONTENTSSection Pagei. Safety Warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1This product complies with all CE directives pertinent at the time of manufacture. Contactfactory for detailed installation instructions and Declara

I. INTRODUCTIONThe KBSI-240D Signal Isolator is used to isolate, amplify and condition DC voltage and currentsignals from any source (motors, tachs an

FIGURE 1 – CONTROL LAYOUT & MECHANICAL SPECIFICATIONS (INCHES / [mm])(Illustrates Factory Setting of Jumpers and Approximate Trimpot Settings)31MA

Notes:1. To achieve full specifications input voltage must be within ± 10% of nominal.2. Floating (non-grounded) or grounded input signal may be used.

III. WIRING.Warning! Read Safety Warning on page 1before attempting to use this control.A. AC Power – The KBSI-240D is powered with either 115or

i. Current Signal InputWarning! Read Safety Warning on Page 1before attempting to use this control.The Signal Isolator accepts 4 – 20 mA DC input to

ii. Voltage Input SignalWarning! Read Safety Warning on Page 1before attempting to use this control.Note: The Voltage/Current (VLT/CUR) jumper must